Signal to Noise Ratio (SNR) Measurement

Projects you are planning or working on with the Mojo
Post Reply
Posts: 2
Joined: December 30th, 2015, 1:23 pm

Signal to Noise Ratio (SNR) Measurement

Post by mei123 » February 24th, 2017, 1:58 am

I would like to measure SNR of an acoustic signal where the frequency of the signal is 37.5 kHz. Theoretically, this can be done by performing FFT on a sampled data of the signal. My question can I directly pass the data into the Mojo board? Do I need an external ADC?

Thank you.

Site Admin
Posts: 834
Joined: March 24th, 2013, 12:45 pm

Re: Signal to Noise Ratio (SNR) Measurement

Post by embmicro » February 28th, 2017, 1:10 pm

If you want to do any accurate analog measurements like SNR, I'd recommend using an external ADC. You can use the ADC from the AVR but the default firmware isn't really setup for this kind of thing and the time between samples may not be perfectly fixed. You could modify the firmware to sample things more regularly or use an external ADC.

Actually, I just scoped the datasheet for the ATmega32U4 and it only can sample up to 15KSPs at 10-bit samples so you'll definitely need an external faster one.

Post Reply