Connect to the Mojo in MATLAB

Projects you are planning or working on with the Mojo
Post Reply
Posts: 1
Joined: April 28th, 2016, 11:19 am

Connect to the Mojo in MATLAB

Post by sagittarius_158 » April 28th, 2016, 11:52 am

I have problem in managing contact with Mojo with 3rd party program.
I want use matlab to contact with mojo in serial, but every time i open the COME4 ( mojo v3 COME) the board go off apparently, all LED goes off.
I cant find any solution to this problem.
I am wondering if you face something like this in Vb ?

best regards,

Site Admin
Posts: 834
Joined: March 24th, 2013, 12:45 pm

Re: Connect to the Mojo in MATLAB

Post by embmicro » April 28th, 2016, 12:56 pm

It sounds like you are somehow getting the Mojo into programming mode. This happens when you toggle the DTR line a few times in quick succession on the virtual serial port. When you connect in MATLAB what settings are you using?

Post Reply