Page 1 of 1

ISE to Mojo IDE

Posted: December 2nd, 2017, 11:16 am
by danirockdude2
Hello, I'm very new to the FPGA field (I got previous knowledge of microcontrollers and a little bit of VHDL coding), I'm trying to figure out the connection between the ISE Design Suite and the Mojo IDE (as I've seen that the Mojo Loader isn't necessary anymore).
After downloading the base example and modifying it inside the ISE and then creating a programmable file, I've had no use of it when running the Mojo IDE and uploading the code to the board itself.

In other words, if I would like to code in VHDL I would use the ISE but how will I transfer it to the Mojo IDE for final upload?

Thanks in advance,
Daniel.