Page 1 of 1

Connect to the Mojo in MATLAB

Posted: April 28th, 2016, 11:52 am
by sagittarius_158
Hi
I have problem in managing contact with Mojo with 3rd party program.
I want use matlab to contact with mojo in serial, but every time i open the COME4 ( mojo v3 COME) the board go off apparently, all LED goes off.
I cant find any solution to this problem.
I am wondering if you face something like this in Vb ?

best regards,
mohsen

Re: Connect to the Mojo in MATLAB

Posted: April 28th, 2016, 12:56 pm
by embmicro
It sounds like you are somehow getting the Mojo into programming mode. This happens when you toggle the DTR line a few times in quick succession on the virtual serial port. When you connect in MATLAB what settings are you using?